|
|
- Suggested: Please read over all of the instructions before proceeding.
- Cornerstone Sticker Locations and Application Instructions.
- DO NOT ALLOW ANY PART OF THE LOGO/ BUMPER STICKERS TO TOUCH ITSELF!
- IN DOING SO.....YOUR LOGO/BUMPER STICKER WILL BE RUINED!
- Logo Cut-Outs to be placed on the drivers side rear outside window.
- Bumper Stickers to be placed on the drivers side of rear bumper.
- Remove dirt and clean area with a mild glass cleaner. Let area dry!
- To install the Logo Cut-Out:
- First lay your Logo onto your window to see for the best fit.
- Once your location is chosen, make sure you have the words facing you so you can read them.
- There is a protective paper on both of the front and a back of the logo.
- Fold the back side of the protective paper in half.
- Position your logo onto your window, NOW be careful IT WILL STICK! (You may not be able to adjust!)
- Start in the center of the unfolded portion and press down over the window. Pressing out from the center to remove any air bubbles.
- Once this side of the logo is attached to your rear window, remove the other half of the protective paper from the back of the logo and press down on the logo to remove air bubbles.
- Your logo is NOW attached to the rear of your window.
- Now, you need to remove the protective front side paper.
- Pick at one corner to lift the paper from the front of your logo.
- Do not jerk or briskly remove.
- Slide off the front of the protective paper at a 45 degree angle and pull steady and continuously until it is removed.
- Inspect your log for any air bubbles. If you have any under your logo, take a small straight pin and poke a small hole into the bubble and then press out the air.
- Your logo should now be installed. DO NOT USE any harsh chemicals or other liquids on your logo for fear of it coming off.
To install the Bumper Stickers:
First lay your Logo onto your driver side bumper to see for the best fit.
Once your location is chosen, make sure you have the words facing you so you can read them.
There is a protective paper on the back of the logo.
Fold back about a quarter of the way on the back side of the protective paper.
Position your logo onto your bumper, NOW be careful IT WILL STICK! (You may not be able to adjust!)
Start in the center of the unfolded portion and press down over the bumper. Pressing out from the center to remove any air bubbles.
Once this side of the logo is attached to your rear bumper, remove the rest of the protective paper from the back of the logo in small increments and press down on the logo to remove air bubbles.
Your logo is NOW attached to the rear of your bumper.
Inspect your bumper sticker for any air bubbles. If you have any under your sticker, take a small straight pin and poke a small hole into the bubble and then press out the air.
Your bumper sticker should now be installed. DO NOT USE any harsh chemicals or other liquids on your bumper sticker for fear of it fading. USE NO AMMONIA AS THIS WILL REMOVE THE INK ON THE STICKER!
|
|
